₨154,800 ₨170,610
The UPO2102E oscilloscope is a digital oscilloscope with Ultra Phosphor technology from the UPO2000E series. The UPO2102E oscilloscope offers 2 channels with the same characteristics. It is also equipped with sampling rate of 1 GS/s. This is amply sufficient for a bandwidth that is 100 MHz (unlike the lower versions of UPO2072CS, UPO2074CS, UPO2072E and UPO2074E, which are only up to 70 MHz). It is a multifunctional, high-performance oscilloscope that is easy to use, with very good technical specifications. It features a 800 x 480 pixel display. Supports USB storage and PC communication via Plug and play USB. Compared to the previous version UPO2102CS differs in new software (firmware).
| Model | UT3513 |
| Resistance range | 20m Q/200m Q/2Q/20Q /200 Q/2kQ/20kQ |
| Resolution | 1 u Q/10 u Q/100 u Q/lmO/lOmQ/lOOmQ/1 Q/10Q/100Q |
| Test current | 1A/1A/100mA/10mA/1mA/1mA/100 uA/10 u A/l uA |
| Testing terminal opencircuit voltage | ＜1V/＜1V/＜1V/＜1V/＜5V/＜5V/＜5V/＜5V/＜3V/ |
| Measured parameter | DC resistance |
| Basic accuracy | Slow: 0. 1%; Medium: 0. 2% |
| Maximum reading | 22000 |
| Range mode | Auto/Manual/nominal |
| Calibration | Short-circuit full range zeroing |
| Sorting function | 3types of resistance and voltage input: exceeds upper limit/exceeds lower limit/within the range,2 types of sorting result output: PASS/FAIL |
| Comparing method | Absolute tolerance, percentage tolerance, direct-reading comparison |
| Trigger mode | Internal, external |
| Test terminal | Four-terminal measurement |
| Button functions | Lock 一一 keyboard lock, OK 一一 screenshot |
| System setup | Language: Chinese/English, key tone setting |
| Interfaces & protocols | Handler interface, RS232, USB DEVICE and USB HOST communication interface,SCPI and Modbus protocol |
| Upper computer software | V |
| Power | AC 100~240V 50/60Hz |
| Display | 4.3-inches LCD |
The Tester is a handheld and battery operated very convenient small Tool that is specially used to measuring SMD (Surface Mounting Device), there are Chip type resistor, Chip type capacitor, and diode. Moreover, the Tester also has the continuity checking function.
● Display 3000 counts
● Auto Ranging
● Auto Power Off
● Data Hold
● Low Battery Display
● Auto Scanning
● Diode Check Open Voltage 2.8V
● Diode Testing Current 2mA
● Continuity Buzzer <30Ω
1、Automatic waveform and status configuration；
2、Storage of waveforms, setups and interfaces; waveforms and setups reproduction
3、Screen copy function；
4、Fine window extension; precise analysis of waveform details and overview；
5、Unique waveform recording, storage and replay function；
6、HD color 5.7 inch LCD panel at 320 x 240 pixel aspect ratio；
7、Multiple waveform mathematics functions (including add, subtract, multiply and divide)；
8、Multimeter function；
9、USB drive system software upgrade.
1. 2 channels
| Analog bandwidth | 150MHz | 250MHz | ||
| Channels | 2+16 digital | 4+16 digital | 2+16 digital | 4+ 16digital |
| Sampling rate (Analog) | 2.5GS/s (Single channel), 1.25GS/s (Dual channels) | |||
| Sampling rate (Digital) | 1.25GS/s (Eight channels), 625MS/s(Sixteen channels) | |||
| Memory depth | 70Mpts | |||
| Waveform capture rate | 200,000wfms/s | |||
| Time base scale | 2ns/div~50s/div (Real-time sampling rate, memory depth display ) | |||
| Time base scale (digital) | 2ns/div~40S/div[Step by 1-2-4 stall] | |||
| Input impedance | (1MΩ±1%) II (20pF±3pF) | |||
| Input impedance digital | (101kΩ±1%) II (9pF±1pF) | |||
| Vertical scale | 1mV/div~20 V/div (1 MΩ) | |||
| DC gain accuracy | <5mV: ±3%, ≥5mV: ±2% | |||
| Waveform record | 100,000 frames | |||
| Trigger types | Edge, Runt, Window, Nth Edge, Delay, Overtime, Duration, Setup/Hold, Pulse Width, Slop, Video, Code; RS232/UART, I2C, SPI, USB, CAN, LIN, FlexRay |
|||
| Bus decode | RS232/UART, I2C, SPI, USB, CAN, LIN, FlexRay | |||
| Waveform operations | A+B, A-B, A×B, A/B, FFT, editable advanced and logical operations | |||
|
Auto measurements |
Max, Min, High, Low, Ampl, Pk-Pk, Middle, Mean, CycMean, RMS, CycRMS, Period, Freq, Rise, Fall, RiseDelay, FallDelay, +Width, -Width, FRR, FRF, FFR, FFF, LRF, LRR, LFR, LFF, +Duty, -Duty, Area, CycArea, OverSht, PreSht, Phase, 34 parameters in totaldigital channel: Freq, Period, +Width, -Width, +Duty, -Duty, RiseDelay A→B,FallDelay A→B, Phase A→B, Phase B→A |
|||
| Measurement display | 5 types | |||
| Measurement statistics | Average, Max, Min, standard deviation and number of measurements | |||
| Frequency counter | 6 bits | |||
| Standard interfaces | USB Host, USB Device, LAN, EXT Trig, AUX Out (Trig Out, Pass/Fail), AWG,UT-M15 logic analyzer probe, VGA | |||
|
Standard Accessories |
USB interface cable | UT-D14 | ||
| Passive Probe x 2/4 (1 x , 10 x switchable,300MHz,) | UT-P06 | |||
| Passive Probe x 2/4 (1 x , 10 x switchable,200MHz,) | UT-P05 | |||
| 16CH Logic analyzer probe | UT-15M | |||
Specifications and features:
1. 2 channels,1GS/s sample rate
2. 200MHzbandwidth, 16Mpts maximum memory depth
3. Waveformacquisition rate is up to 150,000wfms/s
4. Verticalsensitivity: 2mV/div~5V/div
5. Time-basedrange: 2ns/div~50s/div
6. Trigger modes:edge, pluse, runt, video, slope, alternate
7. Customized AUTO,fast captures the signals
9. Supports Y-T andX-Y mode at the same time, can observe Lissajous waveform
10. 34 kinds ofauto measurements
11. Optional LAmodule
12. Standardinterfaces: USB Host，USBDevice，Pass/Fail
13. 7-inch TFT LCD，WVGA (800*480)
UTS 3030D SPECTRUM ANALYZER 
UT A61 Food Temperature Meter 
Pride Long Nose Plier (Plas) High Quality 
Digital Clamp Meter 266 in pakistan 
There are no reviews yet.