-
×
UT81C Scope Digital Multimeter
- Vendor:
superworld
Subtotal: ₨90,000
-8%
Analog Multimeters
ANALOG METER DE 360
Features Of Analog Multimeter DE360TRN:
- Tests AC voltage, DC voltage, DC current, resistance, continuity and batteries.
- 20kOhm/V DC sensitivity.
- Mirrored scale.
- With fuse overload protection circuitry incorporated.
- Easy to read, colour-coded analogue displays.
- Manual range selection.
- Pocket-sized analogue tester.
₨1,700 ₨1,853
Analog Multimeter DE360TRN
Analog Multimeter DE360TRN is easy to read, colour-coded analogue displays. Analog meter DE360TRN, you can use it to measure AC/DC voltage, DC current, resistance, diode check, continuity and transistor leak current, for DC current. This meter can measure as low as 10 microamps and up to 250 mA, which is hard to do with a digital multimeter. The acts as an ammeter with low series resistance to measure direct current. For measuring high current, we connect a shunt resistor across the galvanometer so that the current through the galvanometer does not cross its maximum allowed value. Here, a significant portion of the current to be measured bypasses through the shunt. With that shunt resistance, an analogue multimeter can measure even milli-ammeter or ammeter ranges of current.
Specifications Of Analog Meter DE360TRN Analog Ohmmeter:
- DCV: 0 – 0.1V ±1% 0.25V/2.5/10V/50V/250/1000 ±3%
- ACV: 0 -10/50/250/1000V ±4%
- DCA: 0 – 50µA/2.5mA/25mA/250mA ±3%
- Resistance: 0 – 2K/20K/200K/2M/20Mohm ±3% *dB: -10 dB – 22 dB
- Light: Diode check (including LED)
- Continuity: both Buzzer & flash
- Transistor leak current Features: All range fused
- Compact size
- Tilt back-stand
- Continuity flash
- 0-ohm adjustment
Brand
China Brand
Based on 0 reviews
Be the first to review “ANALOG METER DE 360”
-
Wire & Cable Testers
LKZ-720 Wires and pipe locator
Features:
- the function 3D in the receiver – detecting the direction of current flow and accurate locating the object,
- phase detection mode,
- receiver operation with four transmitters at the same time to locate interruptions or distinguish wires,
- a LED bright torch,
- headphone socket in receiver,
- screens backlight for work in dark,
- transmission battery status and settings of the transmitter to the receiver
- operation in wide range of rated voltage, up to 500V RMS,
- measurement of voltage at the object to 500 Vrms,
- three levels of transmitter amplification,
- automatic or manual selection of transmitter operation modes,
- five modes of wire tracer operation – voltage, current, current-voltage, power and clamp,
- software upgrade via USB,
- additional accessories enable precise localization – such as contact or non-contact probes and measurement clamp.
SKU: n/a -
Oscilloscopes
UTD2102CEX-II Digital Storage Oscilloscope
1. 2 channels
2. 70MHz/100MHz bandwidth; 1GSa/s real-time sampling rate3. Up to 28Mpts memory depth4. Calibration signal output: 10Hz, 100Hz, 1kHz (by default),10kHz or 100kHz5. Max 10Mpts waveform record6. 8-inch TFT LCD, WVGA (800X480)SKU: n/a -
-
Clamp Meters
UT219M ACA Professional Clamp Meters with Motor Test
- UT-219 professional clamp meter series is three-proofing digital clamp meter specially designed for professional industrial users.
- The industrial design of this series is rugged and durable, and capable of withstanding the impact from 2 meters fall-down.
- The waterproof rating is up to IP54; therefore, it can be used in environment with water splashing or much more dust. The whole series is configured with LoZ (Low Impedance Input) AC voltage tap position, which is capable of testing the false voltage; auto backlight function can be used continuously under the circumstance of emergency power outage. UT-219M is also provided with MOTOR test function, allowing to directly test the phase sequence of three phase AC motor by means of the probe. UT-219 series is much more in compliance with CAT IV 600V safety level, and certified by the German GS institution.
SKU: n/a -
Phase Detector Meters
TKF-12 Phase Sequence Tester
Phase sequence indication (direction of field rotation) in the power network with rated phase-to-phase voltage (120…690 V) AC by LED signalization.
Operation in the power network with frequency range 10…70 Hz.
Indication of the voltage presence in the particular phases by neon lamps signalization.
Power supply from the tested network (continuous operation to 15 minutes for max. voltage).
Protection against faulty indication of field rotation.SKU: n/a
Related products
-
Analog Multimeters
ANALOG METER YX 960 TR
Features Of YX-960 TR Handheld Analog Multimeter:
- Excellent DC resolution factor of 2mV.
- Expanded resistance measurement from 020 to 200M.
- Series capacitor DC to enable measurement of only AC components.
- A large and bright meteor with a scale length of 80mm.
- The sensitivity of 44pA at full scale.
- Fuse and diode protection.
- Measures hFE of transistor directly.
SKU: n/a
There are no reviews yet.