TDR-410 Cable Fault Locator

Availability:

Out of stock
Add to Wishlist
Compare

  • Features:

    • automatic or manual mode:
      • the automatic fault location (AFL),
      • mode with manual range selection and sensitivity,
      • single measurement triggered manually or scanning continuous,
    • 11 available ranges from 7 m to 4000 m selected in manual mode or matched automatically,
    • maximum length of cable up to 4000 m one end of the cable,
    • “Dead zone” measure limited to 0.5 m,
    • 2.5 “LCD screen with backlight,
    • scan automatically or manually trigger,
    • sensitivity set manually or automatically adjusted,
    • adjustable impedance matching,
    • propagation coefficient adjustment 1% to 99%,
    • waterproof and resistant to mechanical housing.
    • small size and weight.
    • economical power system – 30 hours of continuously scan on one battery set..

    Accessories:

    • 0,6 m double-wire lead: WAPRZ0X6DZBB
    • red crocodile clip: WAKRORE20K02
    • Krokodylek czarny: WAKROBL20K01
    • cover M-2: WAFUTM2

₨0

Out of stock

Compare
  • Location damaged power cables.
  • Fault location copper telecom cables.
  • Coaxial cable fault location.
  • Fault location wiring infrastructure.
  • Detection of breaks, short circuits, damage caused by dampness and other changes in impedance of the cable.
  • Graphic depiction of damage the cable with automatic indication the distance to fault on the screen.

Category:

Dechnical data:

  • Ranges Meters: 7, 15, 30, 60, 120, 250, 500, 1km, 2km, 3km, 4km
  • Ranges Feet: 20, 45, 90, 180, 360, 750, 1500, 3000, 6000, 10000, 14000.
  • Range Selection: Manual range control / Auto range.
  • Accuracy: 1% of selected range*.
  • Resolution: Approx 1% of range.
  • Minimum cable lenght: 4m (14ft).
  • Sensitivity: Min 3 pixel return at 4km on 0.6mm Ø, PE, TP.
  • Velocity Factor: Adjustable from 1% to 99%.
  • Output Pulse: 5 volts peak to peak into open circuit.
  • Output Impedance: Selectable 25, 50, 75 & 100 Ω.
  • Output Pulse: Width 3 ns to 3 µs, Automatic with range.
  • Scan Rate: 2 scans/second or scan held, pre set for each range scale.
  • Tone Generator: 810 – 1100Hz.
  • Battery Life: 30 hours continuous scanning.
  • Power Supply: 6 volts 4 x 1.5 AA Alkaline cells, on-screen low voltage indicator.
  • Power Down Selectable: 1, 2, 3, 5 minutes or disabled.
  • Back Lit Display: 128 x 64 pixel.
  • Voltage Protection: 250 volts AC.
  • Operating Temp: -10º / 50ºC.
  • Storage Temp: -20º +70° C.
  • Dimensions: 165 x 90 x 37 mm (6.5 x 3.5 x 1.5 ins).
  • Weight: 350 g (12oz).
  • Safety: IEC 61010-1, EN 60950.
  • EMC: BS/EN 61326-1.
  • Water/Dust Proof: IP54

Brand

SONEL

Based on 0 reviews

0.0 overall
0
0
0
0
0

Be the first to review “TDR-410 Cable Fault Locator”

There are no reviews yet.

  • UT50B Modern Digital Multimeters

    UT50B Modern Digital Multimeters

    0 out of 5
    (0)

    UT 50-II SERIES  digital multimeter  UT-50B with AC current measuring range of 20 mA/200mA/20A modern design with automatic back light.

    SKU: n/a
    ₨3,300 ₨3,543
    Add to cart
    Add to Wishlist
    Compare

  • UT 3550

    UT 3550

    0 out of 5
    (0)

    UT 3550

    SKU: n/a
    ₨500,000 ₨510,000
    Add to cart
    Add to Wishlist
    Compare

  • MIC-15k1 ,15kV Insulation Quality Analyzer

    MIC-15k1 ,15kV Insulation Quality Analyzer

    0 out of 5
    (0)

     

    Features:

    • Diagnostics of insulation systems based on standard measurements of IR, DAR, PI, SV, RT, DD, widened with thepartial discharge (PD) indicator for every each of these measurements.
    • It allows testing the electrical durability of the tested object – breakdown voltage indication.
    • High resistance to electromagnetic interferences guarantees uninterrupted work in power stations and close to high voltage transmission lines up to 1200 kV AC and 500 kV DC.
    • The function of smooth voltage rise in time (RT – Ramp Test) allows to state the partial discharges in the facility and to carry out a partial location of their occurrence.
    • Efficient converter with a power of ~150 W that enables insulation burnout, allowing for pinpointing the location of cables and wires short circuit using one of the following:
      • visual method (if power cables are visible along the entire length),
      • reflectometric methods, seismic-acoustic waves detector, or with A-frame to indicate direction of the fault (the conductor must be buried in the ground with earth direct contact).
    • Compatible with external software.
    SKU: n/a
    ₨0
    Add to cart
    Add to Wishlist
    Compare
  • ,

    JAKEMY JM-B04 Multifunctional Waist Tool Bag

    ,

    JAKEMY JM-B04 Multifunctional Waist Tool Bag

    0 out of 5
    (0)

    Features:

    1. Multi-functional waist tool bag for improving work efficiency.
    2. 600D Oxford cloth material and thicken design, durable for use.
    3. Adjustable belt to fit with most waist sizes.
    4. Multiple pockets for holding tools and easy to use.
    5. Also designed with a small bag on it, convenient to carry small gadgets.
    6. Great for home improvement, woodworking or other repair project
    SKU: n/a
    ₨1,086 ₨1,320
    Add to cart
    Add to Wishlist
    Compare

  • KADA 952 Hot Air and Soldering Station SMD SMT Rework Station

    KADA 952 Hot Air and Soldering Station SMD SMT Rework Station

    KADA
    0 out of 5
    (0)
    SKU: n/a
    ₨10,000 ₨12,000
    Add to cart
    Add to Wishlist
    Compare

  • MRU-30 Earth Resistance and Resistivity Meter

    MRU-30 Earth Resistance and Resistivity Meter

    0 out of 5
    (0)

     

    • It allows to take the measurements of:

      • earthing resistance using auxiliary electrodes,
      • earthing resistance using auxiliary electrodes and clamp (for measurements of multiple earthing),
      • earthing resistance using double clamps for measuring multiple earthing without underground connections.
      • ground resistivity (Wenner method),
      • continuity of equipotential bondings and protective
      • conductors (meeting the requirements IEC 60364) with auto-zero function – with current 200mA.

      Additionally:

      • measurement of resistance of auxiliary electrodes RS and RH,
      • measurement of interference voltage,
      • measurement in the presence of interference voltage in the power network
      • with frequency 50Hz, 60Hz,
      • selection of maximum measuring voltage (25V and 50V),
      • introducing the distance between the electrodes for the resistivity in metres (m) and feet (ft),
      • memory of 990 measurements (10 banks of 99 cells each),
      • calibration of clamp used,
      • data transmission to the computer (USB),
      • indication of battery state.
    SKU: n/a
    ₨0
    Add to cart
    Add to Wishlist
    Compare

Related products

  • LKZ-720 Wires and pipe locator

    LKZ-720 Wires and pipe locator

    0 out of 5
    (0)

    Features:

    • the function 3D in the receiver – detecting the direction of current flow and accurate locating the object,
    • phase detection mode,
    • receiver operation with four transmitters at the same time to locate interruptions or distinguish wires,
    • a LED bright torch,
    • headphone socket in receiver,
    • screens backlight for work in dark,
    • transmission battery status and settings of the transmitter to the receiver
    • operation in wide range of rated voltage, up to 500V RMS,
    •  measurement of voltage at the object to 500 Vrms,
    • three levels of transmitter amplification,
    • automatic or manual selection of transmitter operation modes,
    • five modes of wire tracer operation – voltage, current, current-voltage, power and clamp,
    • software upgrade via USB,
    • additional accessories enable precise localization – such as contact or non-contact probes and measurement clamp.
    SKU: n/a
    ₨200,000 ₨210,000
    Add to cart
    Add to Wishlist
    Compare

  • MS6812 Cable Tracker

    MS6812 Cable Tracker

    0 out of 5
    (0)

    The Cable Tracker is designed to identify and trace wires or cables within a group without damaging the insulation.For telephone line, it can identify some state in the line, and more convenience to install, debug, maintain telephone line.There is a Sender(MS6812-T) and a Receiver(MS6812-R)included in The Cable Tracker

    ● Sound and Light Instruction
    ● Cont and Tone LED Light

    Applications
    – Judge Continuity of the Cables or Wires
    – Track the Cables or Wires, and Diagnose the Break Point
    – Receive the Tone Signal on the Cables or Wires(Telephone Line)
    – Identify the State in the Working Telephone Line(Clear, Ringing, Busy)
    – Send a Single Solid or a Dual Alternating Tone to the Target Cables or Wires

    SKU: n/a
    ₨2,631 ₨3,291
    Add to cart
    Add to Wishlist
    Compare

  • TDR-420 Time Domain Reflectometer/ Cable Fault Locator

    TDR-420 Time Domain Reflectometer/ Cable Fault Locator

    0 out of 5
    (0)

    Product features

    • Possibility damage-free location of impedance changes of tested cables and wires such as:
      • shorted conductor,
      • open conductor / end of cable – useful during the inventory of warehouses and stores,
      • splice,
      • splitter,
      • water ingress,
      • wet splice,
      • bridge tap
      • or other changes.
    • Single measurement mode ONCE,
    • Continuously measurement mode CONT,
    • Tone signal generator TONE,
    • Two cursors to mark two places of damage along with an indication of the distance between them,
    • Built-in HELP function for easier interpretation of the reflectogram,
    • 11 available measuring ranges from 7 m to 6000 m,
    • „dead zone” limited to 0.6 m,
    • Color 3,5” LCD TFT display with resolution 320 x 240 pixels,
    • manually set of sensitivity in 8 steps GAIN,
    • output impedance regulation up to 200 Ω (possibility of measuring pre-insulated pipes),
    • Velocity of Propagation set in range from 10% to 99%,
    • tight and durable housing with IP67 ingress protection degree.
    • Small size and weight.
    SKU: n/a
    ₨0
    Read more
    Add to Wishlist
    Compare

  • LKZ-1000 Wires and pipe locator

    LKZ-1000 Wires and pipe locator

    0 out of 5
    (0)
    • Passive or active modes of tracing.
    • Detection of underground live wires.
    • Detection of underground wires with no voltage (radio mode).
    • Detection of underground wires with no voltage using a transmitter (galvanised, inductive or clamp-based connection).
    • Tracing metallic or non-conductive pipes using an additional probe.
    • Tracing non-conductive pipelines using a “floating” probe.
    • Tracing a determined cable.
    • Determining the depth of a cable.
    SKU: n/a
    ₨922,500 ₨12,022,500
    Add to cart
    Add to Wishlist
    Compare
Got Questions ? Call us 24/7! 03324478447
© Mart pakistan.com , best price in pakistan - All Rights Reserved
Got Questions ? Call us 24/7! 03324478447