-
×
UTi165A Thermal Imager UNI-T
- Vendor:
superworld
Subtotal: ₨88,800
-92%
Wire & Cable Testers
LKZ-1000 Wires and pipe locator
- Passive or active modes of tracing.
- Detection of underground live wires.
- Detection of underground wires with no voltage (radio mode).
- Detection of underground wires with no voltage using a transmitter (galvanised, inductive or clamp-based connection).
- Tracing metallic or non-conductive pipes using an additional probe.
- Tracing non-conductive pipelines using a “floating” probe.
- Tracing a determined cable.
- Determining the depth of a cable.
₨922,500 ₨12,022,500
- Passive or active modes of tracing.
- Detection of underground live wires.
- Detection of underground wires with no voltage (radio mode).
- Detection of underground wires with no voltage using a transmitter (galvanised, inductive or clamp-based connection).
- Tracing metallic or non-conductive pipes using an additional probe.
- Tracing non-conductive pipelines using a “floating” probe.
- Tracing a determined cable.
- Determining the depth of a cable.
Brand
SONEL
Based on 0 reviews
Be the first to review “LKZ-1000 Wires and pipe locator”
-
Multimeters
UT195DS Professional Digital Multimeters
1. IP65 rating, 2m drop proof, CAT III 1000V, CAT IV 600V
2. Large 6000-count LCD screen
3. 5/s sampling rate
4. True RMS
5. ACV 750V 5kHz bandwidth
6. (AC+DC) or (AV+FREQ) , dual mode
7. Flashlight
8. Auto LCD backlight controlled by light sensor (can be turned off)
9. LoZ voltage test, for ghost voltage measurement
10. Motor phase sequence measurement with 2 probes
11. 20A current measurement (max 30 seconds)
12. 31 analogue bar
13. Low pass filter, 1kHz 3dB attenuation
SKU: n/a -
Watt Meter
UT71E Intelligent Digital Multimeters
1. 40,000 counts, and basic DCV accuracy of 0.025%
2. Can set the interval for auto data recording
3. MAX/MIN/REL measurement mode
4. Peak hold
5. Analogue bar graph
6. Measure AC and DC in the same stall (AC+DC)
7. 4-20mA loop test
8. 45Hz~100kHz frequency response measurement
9. Double backlight
10. Misplug alarm
11. Auto and manual ranges selectable
12. USB interface available
13. Bluetooth connection with a cellphone for data monitoring
14.Power measurement mode
15. Temperature measurement mode, equipped with K-type point contact temperature probe
16. Complies with CE (European Union) and UL (United States) directives
SKU: n/a
Related products
-
Wire & Cable Testers
TDR-410 Cable Fault Locator
-
Features:
- automatic or manual mode:
- the automatic fault location (AFL),
- mode with manual range selection and sensitivity,
- single measurement triggered manually or scanning continuous,
- 11 available ranges from 7 m to 4000 m selected in manual mode or matched automatically,
- maximum length of cable up to 4000 m one end of the cable,
- “Dead zone” measure limited to 0.5 m,
- 2.5 “LCD screen with backlight,
- scan automatically or manually trigger,
- sensitivity set manually or automatically adjusted,
- adjustable impedance matching,
- propagation coefficient adjustment 1% to 99%,
- waterproof and resistant to mechanical housing.
- small size and weight.
- economical power system – 30 hours of continuously scan on one battery set..
Accessories:
- 0,6 m double-wire lead: WAPRZ0X6DZBB
- red crocodile clip: WAKRORE20K02
- Krokodylek czarny: WAKROBL20K01
- cover M-2: WAFUTM2
- automatic or manual mode:
SKU: n/a -
-
Wire & Cable Testers
UT681HDMI Cable Tester
1. Tests HDMI/MINI-HDMI cables
2. Fastline collocation type: A with A, A with C and C with C
3. Checks circuit breakage, short circuit, cross circuit and the missing wire
4. 20 visible LED indicators
5. Can toggle between scan and full display test modes
6. Single key operation
7. Manual/auto power off (after 10-minute inactivity)
8. Low battery indication
9. CE certification
10. Power supplied by 9V layer-built battery
SKU: n/a -
Wire & Cable Testers
UTP 03 60MHZ PROBE
Attenuation ratio: 1× and 10× optional.
Portable design according to ergonomics.
Integral injection moulding makes the usage more flexible and the oscillograph able to adapt more testing situations.
Safety standards: it has passed the CE Attestation of the European Community.
Compatible with domestic and international digital and analogue oscilloscopes in relevant frequency.
Measurement in intermediate and low-frequency signals.
Accessories included by PP series passive voltage rapier.
Adjusting tool: adjusts compensation capacitance to assure the rapier match with oscillograph.
Contractive-type acuminate hook.
12cm earth wire with an alligator clip.
Locating sleeve adapts to IC testing.
Double-nip wire.
SKU: n/a
There are no reviews yet.