-
×
UT50B Modern Digital Multimeters
- Vendor:
superworld
Subtotal: ₨3,300
-92%
Wire & Cable Testers
LKZ-1000 Wires and pipe locator
- Passive or active modes of tracing.
- Detection of underground live wires.
- Detection of underground wires with no voltage (radio mode).
- Detection of underground wires with no voltage using a transmitter (galvanised, inductive or clamp-based connection).
- Tracing metallic or non-conductive pipes using an additional probe.
- Tracing non-conductive pipelines using a “floating” probe.
- Tracing a determined cable.
- Determining the depth of a cable.
₨922,500 ₨12,022,500
- Passive or active modes of tracing.
- Detection of underground live wires.
- Detection of underground wires with no voltage (radio mode).
- Detection of underground wires with no voltage using a transmitter (galvanised, inductive or clamp-based connection).
- Tracing metallic or non-conductive pipes using an additional probe.
- Tracing non-conductive pipelines using a “floating” probe.
- Tracing a determined cable.
- Determining the depth of a cable.
Brand
SONEL
Based on 0 reviews
Be the first to review “LKZ-1000 Wires and pipe locator”
-
Tool Kits
JM-Y02 Precision Electronic Screwdriver Set For Maintenance
Application:
Cell phone/Tablet/Camera/Laptop/Glasses
Feature:
Brand: JAKEMY
Model: JM-Y02
Name: Electric screwdriver set
Torsion: 0.1-2.5kgf.cm
Speed: 395 r/min
MAH: 800 mA
Rated output voltage: 3.7 V
Duration: 3 H
Product material: Aluminum alloy Shell, Anodized surfaceUsage:
Phillip 1.5: for Samsung, MI
Slotted 2.0: for iPhone
Torx T2: for Huawei, OPPO and VIVO
Pentalober(Star): for iPhone
Mainboard Phillips, Tri-wing:0.8: for new iphone 7 and above modelsSKU: n/a -
Tool Kits, Tools and Hardware
JM-8101 Precision Screwdriver Tool Kit
Features:
- Adjustable screwdriver bits for different screws.
- Finest CR-V bits with HRC up to 52 ℃.
- Common used in precision work in electronics, DIY models, jewelry, eye glasses and other home appliances.
- Curved tip tweezer common used in mini electronic components.
- Portable box with transparent cover.
SKU: n/a -
Soldering Iron
Mechanic Special Solder Paste XG-50 35G 183°C
This is solder paste for soldering small SMD components in a reflow oven or with a hot air soldering station. comes in a small container for prototyping or repairing job.This pack is the right amount of solder paste for most hobby projects. This paste is the replacement for solder wire used in Through-hole soldering, some times solder flux is referred to as solder paste.
SKU: n/a
Related products
-
Wire & Cable Testers
UT681L Cable Tester
Main Features
1. Tests Ethernet cables and telephone lines
2. Equipped with RJ45 interface for Ethernet cable and RJ11 interface for telephone line testing
3. Ethernet cables: Shielded/Unshielded test
4. Visible LED indication
5. Automatically check circuit breakage, short circuit and cross circuit
6. Can toggle between fast and slow speed test modes
7. Single key operation
8. Manual/auto power off (after 10-minute inactivity)
9. Low battery indication
10. Power supplied by 9V layer-built battery
SKU: n/a -
Wire & Cable Testers
UT18D Voltage and Continuity Tester
1. Auto power off, the conductor to be measured is greater than 12V
2. Phase rotation test3. Continuity test with buzzer and LED indication4. Low battery indication and over voltage prompt5. Flashlight6. Test live voltage without batteries7. Buzzer and silent modes available8. Auto range9. Polarity indicationSKU: n/a -
Wire & Cable Testers
TDR-420 Time Domain Reflectometer/ Cable Fault Locator
Product features
- Possibility damage-free location of impedance changes of tested cables and wires such as:
- shorted conductor,
- open conductor / end of cable – useful during the inventory of warehouses and stores,
- splice,
- splitter,
- water ingress,
- wet splice,
- bridge tap
- or other changes.
- Single measurement mode ONCE,
- Continuously measurement mode CONT,
- Tone signal generator TONE,
- Two cursors to mark two places of damage along with an indication of the distance between them,
- Built-in HELP function for easier interpretation of the reflectogram,
- 11 available measuring ranges from 7 m to 6000 m,
- „dead zone” limited to 0.6 m,
- Color 3,5” LCD TFT display with resolution 320 x 240 pixels,
- manually set of sensitivity in 8 steps GAIN,
- output impedance regulation up to 200 Ω (possibility of measuring pre-insulated pipes),
- Velocity of Propagation set in range from 10% to 99%,
- tight and durable housing with IP67 ingress protection degree.
- Small size and weight.
SKU: n/a - Possibility damage-free location of impedance changes of tested cables and wires such as:
There are no reviews yet.