- Detection of wires and cables (live or not)
- detection of cables in ceilings, walls and floors,
- detection of breaks in cables,
- tracing cables in building installation,
- locating power points and switches in buildings,
- locating short circuits between leads,
- tracing shielded cables,
- tracing cables in metal ducts.
- Identification of fuses on the distribution board.
- Tracing underground cables.
- Tracing conductive water and heating pipelines.
- Non-contact detection of live cables.
LKZ-720 Wires and pipe locator
2 in stock
Features:
- the function 3D in the receiver – detecting the direction of current flow and accurate locating the object,
- phase detection mode,
- receiver operation with four transmitters at the same time to locate interruptions or distinguish wires,
- a LED bright torch,
- headphone socket in receiver,
- screens backlight for work in dark,
- transmission battery status and settings of the transmitter to the receiver
- operation in wide range of rated voltage, up to 500V RMS,
- measurement of voltage at the object to 500 Vrms,
- three levels of transmitter amplification,
- automatic or manual selection of transmitter operation modes,
- five modes of wire tracer operation – voltage, current, current-voltage, power and clamp,
- software upgrade via USB,
- additional accessories enable precise localization – such as contact or non-contact probes and measurement clamp.
₨200,000 ₨210,000
2 in stock
CompareElectric security:
- type of insulation: double, according to EN 61010-1
- measurement category: CAT III 600V acc. to EN 61010-1
- transmitter’s protection class acc. to EN 60529: IP67
- receiver’s protection class acc. to EN 60529: IP40
Other technical data:
- transmitter’s power supply: four AA alkaline battery or NiMH rechargeable battery
- transmitter’s max working voltage: 500 Vrms (707 Vampl)
- detector’s max range („I” mode) 2m
- non-contact neon max range: 20 cm (in air), 3 cm (in concrete)
- receiver’s power supply: battery 9V 6LR61 alkaline
Rated operational conditions:
- operating temperature -10°C…+50°C
Based on 0 reviews
Be the first to review “LKZ-720 Wires and pipe locator”
-
Environment Meters
UT337A Carbon Monoxide Meter
UT337A is a portable carbon monoxide meter with wide detection range, short response time, long term stability, and long service life. It provides many functions such as CO concentration display, maximum value, average value, audible and visual alarm, temperature display, etc. It is suitable for carbon monoxide detection in residential homes, restaurants, indoor parking lots and gas heating facilities.
Features:
1. High-sensitivity electrochemical sensor
2. Light and sound alarm
3. Sensor self-check
4. Battery powered, 20 minutes automatic power off
5. Portable
6. The alarm value of CO can be set
7. Maximum value
8. Temperature
9. LCD backlight
SKU: n/a -
Battery Testers
Battery Load Tester – BT 100A
-
Sleek Design Silver Metal Body
- Easy To Use
- Convenient portable size and easy-to-read scales
- Tests batteries on or off the car in just 10 seconds
- Determines good/bad status with an extra-large display with zero adjust
- Determines state-of-charge cranking and charging volts
- Works on both 6 Volts and 12 volts batteries
SKU: n/a -
-
LCR Meter
UT620 Series Digital Micro Ohm Meters
UT620 series are used to measure DC low resistance through 4-wire method. Some of its features are: Comparison function to determine if the device is in good condition, unknown wire length calculation (FT/M); two-way data transmission by USB interface; built-in rechargeable lithium battery. UT620 can be used in narrow space for on-site troubleshooting, such as metal coating resistance/motor and small transformer winding resistance measurement, earth system joints/welding points/power distribution cabinet bus and lead connection inspection and more.
SKU: UN62B0TUOM -
Clamp Meters
CLAMP METER AC BM 2000B
SPECIFICATIONS:
– Maximum display: 1999
– Method indication: LCD
– Maximum arm span: 60mm
– Operating temperature range:
work: 0C – 40C
Storage:-10C – 60C
– Power supply: 9V battery
– Low battery indication: YES, graphic symbol
– Audible indication: YES, piezoelectric transducer
– Dimensions: 270x100x45 mm
– Weight: about 610g (with battery)Features
– Measuring voltage: 0-1000V 2 range
– Measurement of AC voltage: 0-700V in 1 range
– Measurement of alternating current: 200A-2000A in 2 ranges
– Measuring current: 200A-2000A in 2 ranges
– Measurement of resistance: 2k in 1 range
– Measuring capacity: NO
– Frequency: NO
– Temperature measurement: NO
– Testing LEDs: YES
– Acoustic continuity tester: YES
– Distance between arms: 6cm
– Meter dimensions: 270x100x45 mm
– Weight: 610g with battery
– Basic accuracy: ± (0.5% +2 digits)Packages Include:
1 × Clamp-On Meter BM-2000B
An internal link is any link from one page on your website to another page on your website. Both your users and search engines use links to find content on your website. Your users use links to navigate through your site and to find the content they want to find. Search engines also use links to navigate your site. They won’t find a page if there are no links to it. There are several types of internal links. In addition to links on your homepage,mean post feed, etc, you can also add links within your content. We call those contextual links. Contextual links point your users to interesting and related content.
SKU: n/a -
Usb Tester
UT658C USB Testers
Features of UT658 Series USB Testers
Certifications: CE, UKCA
● Type-A/C interface
● CE certification
● 10 sets of data storage
● Loop equivalent resistance measurement (1-480Ω)
● Same screen shows voltage, current, power, capacity, etc.
● Support fast charge protocol
SKU: 0000
There are no reviews yet.